FreeFitnessCalculators

Running Pace Calculator Guide: How to Calculate Pace and Predict Race Times

Asad Khan, MBBS
November 14, 2026
7 min read
Running Pace Calculator Guide: How to Calculate Pace and Predict Race Times
Share

Featured image: custom illustration by Free Fitness Calculators.

Your running pace is the time it takes you to cover one kilometre or one mile — your finish time divided by the distance you ran. A 25-minute 5K, for example, is 5:00 per kilometre, or about 8:03 per mile. Once you know your pace, you can set training paces and predict race times at other distances.

How to calculate running pace

Pace, time and distance are linked by three simple formulas. Learn one and the other two follow:

Pace = total time ÷ distance

Finish time = pace × distance

Speed = distance ÷ time

Work in seconds to keep the arithmetic clean. A 25-minute 5K is 1,500 seconds, so the pace is 1,500 ÷ 5 = 300 seconds per kilometre — 5:00 per kilometre. Our running pace calculator does this for you, in minutes per kilometre or per mile.

One mile is exactly 1.609344 kilometres, so pace per mile is pace per kilometre multiplied by 1.609344. A 5:00 per kilometre pace becomes 300 × 1.609344 = 483 seconds per mile, or 8:03 per mile.

Worked example: a 25-minute 5K

Take a runner who finishes a 5K in 25:00:

  • Time in seconds: 25 × 60 = 1,500 seconds
  • Pace per kilometre: 1,500 ÷ 5 = 300 seconds, or 5:00 per km
  • Pace per mile: 300 × 1.609344 = 483 seconds, or 8:03 per mile
  • Speed: 5 km in 25 minutes is 5 ÷ (25 ÷ 60) = 12 km per hour, or about 7.5 mph

The same runner's pace at other distances is not the same number — nobody holds 5K pace through a marathon. The next section explains how pace changes as distance grows.

Pace conversion table

Pace per kmPace per mileSpeed (km/h)Speed (mph)
4:307:1513.38.3
5:008:0312.07.5
5:308:5110.96.8
6:009:3910.06.2
7:0011:168.65.3

Read the table either way: a runner holding 6:00 per kilometre is moving at 10 km per hour. Pin the conversion for your target pace before race day rather than doing it mid-run.

Predicting race times with the Riegel formula

The best-known way to predict a finish time at a new distance is the Riegel formula, published by research engineer Peter Riegel in Runner's World in 1977 and based on world records across distances. It says time grows slightly faster than distance, because fatigue accumulates over longer races:

T2 = T1 × (D2 ÷ D1)1.06

T1 is your known time over distance D1, T2 is the predicted time over the target distance D2, and 1.06 is the fatigue exponent. Each time the distance doubles, the predicted time multiplies by about 2.085 rather than 2, so pace slows by roughly 4 percent per doubling. The formula is most reliable between similar distances — 5K to 10K, or 10K to half marathon — and for trained runners. Accuracy falls for large jumps, such as a marathon predicted from a 5K. In a study of 2,303 recreational runners, Riegel's formula was on average right for the 10K and half marathon, but for the marathon it predicted times 10 minutes or more too fast for about half of them.

Apply it to our 25-minute 5K runner:

Target raceCalculationPredicted timePredicted pace
10K25:00 × (10 ÷ 5)1.0652:075:13 per km
Half marathon (21.1 km)25:00 × (21.0975 ÷ 5)1.061:55:005:27 per km
Marathon (42.2 km)25:00 × (42.195 ÷ 5)1.063:59:475:41 per km

Use the nearest recent race as the input, on a similar course. A prediction is a training target, not a race-day promise — heat, hills and pacing can move the result by several minutes.

From one race to training paces: Daniels VDOT

Coach Jack Daniels built a second system on the same idea. His VDOT score is the oxygen uptake (VO2) that would explain your race performance, calculated from your speed and how long you sustained it with the Daniels–Gilbert equations, first published in 1979. A 25:00 5K works out to a VDOT of about 38, and a 20:00 5K to about 50. Unlike a laboratory VO2 max, VDOT comes from a race result, so it also reflects running economy.

Daniels then turns one VDOT score into five training paces, each a fixed share of your fitness, so every zone is personal rather than generic:

ZoneShare of fitnessWhat it is forHow it should feel
E — Easy / Long59–74%Aerobic base and recoveryComfortable, full sentences
M — MarathonAbout 80%Marathon race paceSteady; about 5:41 per km for our runner
T — Threshold / TempoAbout 88%Lactate thresholdComfortably hard, short phrases
I — IntervalAbout 97–100%VO2 max developmentHard; 3–5 minute efforts
R — RepetitionAbout 105–110%Speed and economyFast and short, full recovery

Daniels recommends that roughly 70 to 80 percent of weekly running sits at easy pace, with the rest split between quality sessions. Our VO2 max guide explains the laboratory measure behind VDOT, and our walking calories guide is a starting point for building aerobic volume.

How to use pace in training

Measure pace on a flat, familiar route: GPS watches can be off by a few seconds per kilometre under trees or between tall buildings.

Use pace to set three anchors. Easy runs should be at least a minute per kilometre slower than your 5K pace — for our runner, roughly 6:00 per kilometre or slower, conversational throughout. Tempo runs sit near threshold pace, comfortably hard. Intervals are run at roughly 5K pace or slightly faster, in efforts of 3 to 5 minutes. Heat slows everyone, and hills change pace without changing effort, so effort and the talk test are better guides on those days.

Frequently asked questions

How do I calculate my running pace?

Divide your finish time by the distance. A 25-minute 5K is 1,500 seconds ÷ 5 km = 300 seconds, or 5:00 per kilometre. Multiply by 1.609344 for pace per mile — 5:00 per km is 8:03 per mile.

What is a good running pace?

There is no single good pace: it depends on distance, age, sex and training. A 5:00 per kilometre 5K is a solid club-runner time, while the same pace for a marathon would be exceptional.

How accurate is the Riegel formula?

For trained runners predicting between similar distances, Riegel's formula is typically accurate within 2 to 3 percent. For large jumps, such as 5K to marathon, it often predicts times too fast.

What is VDOT in running?

VDOT is Jack Daniels' fitness score, back-calculated from a race result using the Daniels–Gilbert equations. It sets five personalised training paces — easy, marathon, threshold, interval and repetition — as fixed shares of your fitness.

How do I convert pace per km to pace per mile?

Multiply the pace in seconds per kilometre by 1.609344: 5:00 per kilometre is 300 seconds × 1.609344 = 483 seconds, or 8:03 per mile. To go the other way, divide the per-mile pace by 1.609344.

This guide is general information, not medical advice. Talk to a doctor before starting a vigorous training programme or a maximal exercise test.

Medical Disclaimer: This article is for general information only and is not medical advice. The figures and guidance here are estimates based on published formulas and general health information — they cannot account for your individual health, medical conditions, or medications. Always consult a qualified healthcare professional before changing your diet, exercise, or treatment. See our full Disclaimer.

Sources & References

Dr. Asad Sohrab Khan
Medically Reviewed By✓ Verified Physician

General Physician & Medical Reviewer

Dr. Asad Sohrab Khan is a practicing General Physician (MBBS) who volunteers his medical expertise to review our health and fitness content. He ensures all calculators, articles, and nutritional guidance meet clinical standards for accuracy, safety, and responsible health communication.

Clinical NutritionMetabolic HealthPreventive MedicineBody Composition

Was this article helpful?

Be the first to vote!